ST VRONTI SHIELDS: ZEUS (INSIGNIA-READY)

These Left-handed Saturnus Terminator (ST) Power Shields have a flat surface in the center of the shield, that will allow you to brand them with one of our flat vehicle insignia. The attached arms were designed and sculpted by the free-blade artist, KarnageKing that will fit into any ST:1 Terminator torsos by means of the arm holes under each massive shoulder pads. This way you can attach and position the weapon arms as you wish.

Browse the full lineup of upgrade bits for your miniatures on the Pop Goes the Monkey webstore.

• All products are printed to a 25-micron standard printed to a 25-micron standard using high quality cured resin. Just like any miniature kit it is unfinished, comes unpainted, and unassembled attached to its support structure from the production process.
• Parts are pre-cleaned and ready for primer once removed. Basic hobby skills and tools are required to finish this model. Plastic bases are not included.
• The image shown is the stock photo of the rendered miniature while painted models are for reference only, and not included.
• To remove the bits from their supports: submerge the whole assembly in water that is hot to the touch for 5 minutes. Use your fingernail to punch away several supports to create a starting point, and carefully peel your parts off of the remaining supports altogether. More delicate parts may require clippers or a hobby knife.
• Do not attempt to remove supports from a model while at room temperature. Keep the model out of direct sunlight, or extremely cold temperatures. As always, use caution when working with resin material, and hobby tools.