TUSK System - Tight Bore Designs Upgrade Bits
Share
Details
This is a full TUSK upgrade bits set for an Impulsor or Repulsor tank.
This set contains:
- 1 cupola
- 1 TUSK stand
- 2 guns
- 2 rocket pods
- 2 styles of sensors
These bits are sold unpainted.
These products are officially licensed by Tight Bore Designs.
- All products are printed to a 25-micron standard printed to a 25-micron standard using high-quality cured resin. Just like any miniature kit it is unfinished, comes unpainted, and unassembled attached to its support structure from the production process.
- Parts are pre-cleaned and ready for primer once removed. Basic hobby skills and tools are required to finish this model. Plastic bases are not included.
- The image shown is the stock photo of the rendered miniature, while painted models are for reference only and not included.
- To remove the bits from their supports: submerge the whole assembly in water that is hot to the touch for 5 minutes. Use your fingernail to punch away several supports to create a starting point, and carefully peel your parts off of the remaining supports altogether. More delicate parts may require clippers or a hobby knife.
- Do not attempt to remove supports from a model while at room temperature. Keep the model out of direct sunlight or extremely cold temperatures. As always, use caution when working with resin material and hobby tools.
Make & Care
-
All products are printed to a 25-micron standard using high quality cured resin. Just like any miniature kit it is unfinished, comes unpainted, and unassembled attached to its support structure from the production process.
-
Parts are pre-cleaned and ready for primer once removed. Basic hobby skills and tools are required to finish this model. Plastic bases are not included.
-
The image shown is the stock photo of the rendered miniature while painted models are for reference only, and not included.
-
To remove the bits from their supports: submerge the whole assembly in water that is hot to the touch for 5 minutes. Use your fingernail to punch away several supports to create a starting point, and carefully peel your parts off of the remaining supports altogether. More delicate parts may require clippers or a hobby knife.
-
Do not attempt to remove supports from a model while at room temperature. Keep the model out of direct sunlight, or extremely cold temperatures. As always, use caution when working with resin material, and hobby tools.