2 Sets Stormdrake Guard Custom Medium Flat Magnetic Flight Stands Tall
SKU:MBFSMEF4SDG
These items ship separately from The Magnet Baron's store and will incur a combinable $4.99 shipping charge. Please use this link to contact them for order inquires.
Couldn't load pickup availability
Share
Details
Your GW flight stand doesn't work?
You can't transport it?
Why does it look so... funny?
Replace that untransportable behemoth for a magnetic acrylic flight stand!
This kit works well with:
Stormdrake Guard
Contents:
| Item | Dimensions |
| 2 Acrylic Rods (Undrilled) | 3/8" Diameter x 4" |
| 8 Disc Magnets | 3/8" x 1/8" (10mm x 3mm) |
| Custom Magnet Convertors |
2 Stormdrake Convertors |
| Rock Anchors | 2 Medium |
| 1 Flight Stand Guide | Medium |
Step-By-Step Guide
- Remove the peg from the base and model as cleanly as possible.
- Glue a Rock Adapter to the base.
- Glue a disc magnet inside the rock adapter, or if you don't have an adapter, glue the magnet to the base.
- Glue a disc magnet to the flight stand ensuring that the polarities will attract one another with the magnet you have already glued.
- Repeat step 4 on the other side of the flight stand. Remember, the flight stand is the same on the top and bottom for the Flats, so match the magnets so you don't have to remember up/down.
- Glue the final magnet to the model ensuring that it will also match the magnets you have already glued.
Magnetizing a model with this kit will take about 1-2 minutes in total. You will spend more time trying to clean the superglue off your fingers than assembling these stands.
If you need flight stand or magnetizing kit for a particular model please email me and I will make sure we get to work on it.
Make & Care
Our 3D-printed parts are crafted using high-definition resin at a 25-micron layer height, ensuring exceptional detail and quality far beyond standard resin prints.
To provide maximum protection during shipping, your parts will arrive with supports still attached. But don't worry—removing them is a straightforward process!
Simply apply gentle pressure to easily remove the supports without damaging the parts. We recommend starting with a non-essential area to get comfortable with the process.
Once the supports are removed, you may notice some minor remnants that can be easily smoothed out with additional finishing before priming, especially on smaller or more delicate parts. With a little care and patience, your models will be ready for painting and assembly in no time!
It is recommended to wear appropriate protective equipment when sanding resin. Unless otherwise specified, these items will require assembly, either as their own model or as an upgrade for an existing kit. For best results, gel superglue is recommended.
The image shown is the stock photo of the rendered miniature, while painted models are for reference only and not included.
If you have any questions, we're here to help—happy hobbying!
Any product names, logos, brands, or trademarks mentioned in this listing are used solely to describe compatibility and are the property of their respective trademark holders. These trademark holders are not affiliated with Spikey Bits or its suppliers and do not endorse or sponsor Spikey Bits or its products.
