3 Sets Large Posable Magnetic Flight Stands Snowspeeder Fluttercraft Compatible - Tal
SKU:MBFSLAD3-5SWL
These items ship separately from The Magnet Baron's store and will incur a combinable $4.99 shipping charge. Please use this link to contact them for order inquires.
Couldn't load pickup availability
Share
Details
This kit is primarily for the following ships:
Snow Speeder (T-47 Airspeeder)
This kit is measured to be accurate within 2mm of the original FFG flight stand and therefore be tournament legal.
Contents:
| Item | Dimensions |
| 3 Acrylic Rod (Drilled) | 1/2" Diameter x 3.5" Tall |
| 6 Disc Magnets | 1/2" x 1/8" (12mm x 3mm) |
| 3 Countersunk Ring Magnet | 1/2" x 1/8" (12mm x 3mm) |
| 3 Ball Bearing | 1/2" Diameter |
Step-By-Step Guide
- Remove the peg from the base and model as cleanly as possible
- Glue a disc magnet to the base.
- Glue the other disc magnet to the flat side of the flight stand ensuring that the polarities will attract one another with the magnet you have already glued.
- Glue the ball to the drilled part of the flight stand.
- Glue the ring magnet to the model with the wide opening facing away from the model. The opening is set to fit the ball bearing nicely.
Magnetizing a model with this kit will take about 1-2 minutes in total. You will spend more time trying to clean the superglue off your fingers than assembling these stands.
If you need flight stand or magnetizing kit for a particular model please email me and I will make sure we get to work on it.
The Magnet Baron
Make & Care
Our 3D-printed parts are crafted using high-definition resin at a 25-micron layer height, ensuring exceptional detail and quality far beyond standard resin prints.
To provide maximum protection during shipping, your parts will arrive with supports still attached. But don't worry—removing them is a straightforward process!
Simply apply gentle pressure to easily remove the supports without damaging the parts. We recommend starting with a non-essential area to get comfortable with the process.
Once the supports are removed, you may notice some minor remnants that can be easily smoothed out with additional finishing before priming, especially on smaller or more delicate parts. With a little care and patience, your models will be ready for painting and assembly in no time!
It is recommended to wear appropriate protective equipment when sanding resin. Unless otherwise specified, these items will require assembly, either as their own model or as an upgrade for an existing kit. For best results, gel superglue is recommended.
The image shown is the stock photo of the rendered miniature, while painted models are for reference only and not included.
If you have any questions, we're here to help—happy hobbying!
Any product names, logos, brands, or trademarks mentioned in this listing are used solely to describe compatibility and are the property of their respective trademark holders. These trademark holders are not affiliated with Spikey Bits or its suppliers and do not endorse or sponsor Spikey Bits or its products.
