CHARACTER KIT: CAPTAIN GABRIUM
Share
Details
This conversion kit includes a variety of bits from across the PGTM store, brought together on one sprue. It will allow you to create a one-of-a-kind character for your Chapter or your D-Watch Army.
The kit is designed to fit a random model from the new Prime Marine or Chaos Marine line.* Though the parts very, each kit come with a full set of adjustable arms, 2 full sets of shoulder pads (One specifically prepared for DW), a head swap, a backpack (either standard or jet pack), knee/shin insignia, and weapon load outs (Melee, Ranged and/or Shield).
The preview photo shows you what the sprue will look like. – Note: Base marine model not included.
Browse the full lineup of upgrade bits for your miniatures on the Pop Goes the Monkey webstore.
- All products are printed to a 25-micron standard using high quality cured resin. Just like any miniature kit it is unfinished, comes unpainted, and unassembled attached to its support structure from the production process.
- Parts are pre-cleaned and ready for primer once removed. Basic hobby skills and tools are required to finish this model. Plastic bases are not included.
- The image shown is the stock photo of the rendered miniature while painted models are for reference only, and not included.
- To remove the bits from their supports: submerge the whole assembly in water that is hot to the touch for 5 minutes. Use your fingernail to punch away several supports to create a starting point, and carefully peel your parts off of the remaining supports altogether. More delicate parts may require clippers or a hobby knife.
- Do not attempt to remove supports from a model while at room temperature. Keep the model out of direct sunlight, or extremely cold temperatures. As always, use caution when working with resin material, and hobby tools.
Make & Care
-
All products are printed to a 25-micron standard using high quality cured resin. Just like any miniature kit it is unfinished, comes unpainted, and unassembled attached to its support structure from the production process.
-
Parts are pre-cleaned and ready for primer once removed. Basic hobby skills and tools are required to finish this model. Plastic bases are not included.
-
The image shown is the stock photo of the rendered miniature while painted models are for reference only, and not included.
-
To remove the bits from their supports: submerge the whole assembly in water that is hot to the touch for 5 minutes. Use your fingernail to punch away several supports to create a starting point, and carefully peel your parts off of the remaining supports altogether. More delicate parts may require clippers or a hobby knife.
-
Do not attempt to remove supports from a model while at room temperature. Keep the model out of direct sunlight, or extremely cold temperatures. As always, use caution when working with resin material, and hobby tools.