DARK LEGION - ABHOR: DEMONIC PAULDRONS
Share
Details
This set of Demonic Pauldrons are large enough to fit a Demon Prince model. One shoulder pad incorporates the war band's insignia and the other one is blank. Use one of the 4 Dark Sigils included in this kit to mark your prince with the band of it's Chaotic Patron.
These shoulder pads are sold unpainted, but provide a raised emblem and detail to make painting easy and ensures a consistent, uniform appearance.*
Browse the full lineup of upgrade bits for your miniatures on the Pop Goes the Monkey webstore.
- All products are printed to a 25-micron standard using high quality cured resin. Just like any miniature kit it is unfinished, comes unpainted, and unassembled attached to its support structure from the production process.
- Parts are pre-cleaned and ready for primer once removed. Basic hobby skills and tools are required to finish this model. Plastic bases are not included.
- The image shown is the stock photo of the rendered miniature while painted models are for reference only, and not included.
- To remove the bits from their supports: submerge the whole assembly in water that is hot to the touch for 5 minutes. Use your fingernail to punch away several supports to create a starting point, and carefully peel your parts off of the remaining supports altogether. More delicate parts may require clippers or a hobby knife.
- Do not attempt to remove supports from a model while at room temperature. Keep the model out of direct sunlight, or extremely cold temperatures. As always, use caution when working with resin material, and hobby tools.
Make & Care
-
All products are printed to a 25-micron standard using high quality cured resin. Just like any miniature kit it is unfinished, comes unpainted, and unassembled attached to its support structure from the production process.
-
Parts are pre-cleaned and ready for primer once removed. Basic hobby skills and tools are required to finish this model. Plastic bases are not included.
-
The image shown is the stock photo of the rendered miniature while painted models are for reference only, and not included.
-
To remove the bits from their supports: submerge the whole assembly in water that is hot to the touch for 5 minutes. Use your fingernail to punch away several supports to create a starting point, and carefully peel your parts off of the remaining supports altogether. More delicate parts may require clippers or a hobby knife.
-
Do not attempt to remove supports from a model while at room temperature. Keep the model out of direct sunlight, or extremely cold temperatures. As always, use caution when working with resin material, and hobby tools.