Murmillo Upgrade Conversion Bits For Space Marines Gladiator
SKU:1028387-1Set
3D Printed items ship separately and will incur a separate shipping charge.
Couldn't load pickup availability
Share
Details
If you want to turn your Impulsor into a Gladiator Lancer, Reaper, or Valiant, this new Murmillo tank conversion bits kit makes it easy and affordable to upgrade!
A multipart kit of the Murmillo Tank Upgrade For Hover Tank will be made for you on a high-quality resin printer. It makes a great Gladiator tank upgrade kit for the Space Marines Impulsor, and the back hardtop fits perfectly over top of the Impulsor Tank by Games Workshop with no cutting required.
This Kit Contains:
- back bulkhead (back, door, back vents)
- top turret mounting ring and roof
- turret (bottom, top, back, two antennas, antenna holder)
- all three turret weapon variants (lastalon, gatling, laser+visor bits) to make a Lacer Laser Destroyer, Twin-Linked Las-Talon, or Twin-Linked Heavy Onslaught Gatling Cannons
- 2 side weapon variants (quad bolter and melta)
- hatch and hatch door (the hatch is possible to break in two parts for the open top.
- turret grenade launchers
- Turret Weapons come pre-drilled for magnets so you can swap them out just glue magnets inside the turret before you close it up!
The back door is the same as Bitshapers Repulsor series and fits perfectly with any other Repulsor backdoors.
This product is officially licensed by Bitshapers. If you are after just the .STL files, they are available on Bitshapers Cults Page Here
Instructions for how to assemble your kit are above in the Image Gallery
Miniatures Sales & Marketing Contracted Though Spikey Bits, and Fulfilled By Slicer LLC.
*NOTE: Neither Slicer LLC nor Spikey Bits are affiliated with Games Workshop Group PLC or its affiliates. This product is not designed, manufactured, licensed nor approved by Games Workshop Group PLC, and is not intended to include or infringe any intellectual property rights of Games Workshop Group PLC. Please see our full Terms of Service for more information.
Make & Care
Printed in high definition resin at a 25 micron layer height, these parts will have a higher level of detail compared to standard resin prints.
Each print is provided washed, cured, and with supports removed. However, some support remnants may still be present and could require additional finishing before priming (mostly for smaller, more fragile parts). Carefully use heat and/or clippers to remove any remnants, testing your method on a non-essential area.
It is recommended to wear appropriate protective equipment when sanding resin. Unless otherwise specified these items will require assembly, either as there own model, or as an upgrade for an existing kit. For best results, gel superglue is recommended.
Any product names, logos, brands, or trademarks mentioned in this listing are used solely to describe compatibility and are the property of their respective trademark holders. These trademark holders are not affiliated with Spikey Bits or its suppliers and do not endorse or sponsor Spikey Bits or its products.
